[TenTec] Ten Tec kits counting Toroid turn

[rohre]

All toroid winding is done by counting as a turn the wires passing the inner
diameter of the core.  IE, count the wire as one turn as it goes into the hole
in middle.  That way, you will not get confused with the ends.

Good Luck!
Stuart K5KVH

--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm