[TenTec] RE: Omni V problem

[Rick Williams]

Hi John:

The symptoms you describe happened to my Omni when I was attempting to
build up a supply for it.  When the supply voltage dipped the rig
would do similar strange things.

When I put it back on a known and adequate supply the problem
persisted.

The solution was two fold:

     1) make sure the power supply can deliver the needed current!

     2) push the reset button on the right hand side of the Omni V

TenTec also suggested I try the following reset procedures:

     1) Power down -- push and hold the reset button when you power up
and then after a about 5 seconds release the reset button.

     2) Power down - Hold the CLR/CLK key and power up - release the
CLR/CLK key after you hear the beep!

Does the problem persist when in receive only?  Does it suddenly occur
after the first transmit?  Does it occur at low power?

I hope the problem can be resolved without the need to re-align.  Good
luck,

Rick
VE7ASR


--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm