[TenTec] Blown PS 962

David E. Shelton w4des@iolky.com
Fri, 6 Aug 1999 09:38:42 -0400


Yes you're right James the circuit is completed through the connection to
the Omni V/VI/VI+ so there may not be the damage previously believed to have
occurred.
Replace fuse with proper valued fuse and retry, without the mic connected to
the Omni (G).
73,
Des, W4DES

-----Original Message-----
From: owner-tentec@contesting.com [mailto:owner-tentec@contesting.com]On
Behalf Of James D. Duffer
Sent: Friday, August 06, 1999 7:25 AM
To: Jim Reid
Cc: tentec@contesting.com
Subject: Re: [TenTec] Blown PS 962



> This time,  had presence of mind to disconnect the PS from
> the Omni.  Put in another fuse,  turned on the power -- nothing,
> no pilot light.  Checked the fuse,  was not blown.
>
> So,  obviously I made an error putting in the 10 amp fast blow


Maybe, maybe not......with the power supply disconnected from the Omni
VI, how did you turn the power supply on?  Isn't there a a pair of
wires that must be connected together via the power on/off switch
located on the Omni?  Just wondering, and I haven't taken time to look
at my set up this morning.

Wish you luck with it.

Jim,  WD4AIR

--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm



--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm