[TenTec] FT-1000MP -> Herc II Band select logic

[Richard Thorne]

Duane:

I brought this up a while back.  I can't remember the callsign, but a fella
sent me a file with the circuit to do it.  However, it won't work in my
situation.  I have a HercII built for Kachina, a KC500DC.  Basically identical
except how it changes bands.  The HercII requires a +12v signal, my KC500
requires a ground.

At any rate when I get home I'll send you the file so you can pass it on.

dacalvin@us.ibm.com wrote:

> For some reason my last post came back empty.  I'll try again.
>
> There was a little discussion some time back about interfacing the Herc
> II's band select logic to the Yaesu FT-1000MP for those poor folk who have
> not yet discovered the Omni  :^).   Has anyone done this, or is anyone
> aware of either a kit or schematic for connecting the two together so the
> 1000MP would automatically select the correct band on the Herc II?  This
> request is for a friend who is considering a Herc for his station.
>
>      73,  Duane    AC5AA
>
> Duane A. Calvin
> Server Systems Test Engineer
> Dept. 76TS   RS/6000 - SP Nodes
> IBM Austin, TX      >O<     Tie: 793-3368
>
> --
> FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
> Submissions:              tentec@contesting.com
> Administrative requests:  tentec-REQUEST@contesting.com
> Problems:                 owner-tentec@contesting.com
> Search:                   http://www.contesting.com/km9p/search.htm




--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm