[TenTec] 509 front panel disassembly

[Piotr Tomczak]

Yes it pritty stright forward and easy to do. 
The only acution should be taken while removing the 
tuning knob. They use a amall size hex scrue there.
The band switch is special as well.
So be carefull there too.

Best regards.
Piotr LA9HFA

At 01:54 PM 11/23/99 -0800, you wrote:
>
>I just discovered that the manual for my Argonaut 509 is missing pages 3-2
>and 3-3, which apparently describe front panel disassembly and dial-cord
>replacement/recallibration.
>
>It this particular process non-intuitive in any way?  Can I just take the
>knobs off, unscrew the four screws on the bottom side of the faceplate and
>proceed?
>
>Don
>NR7X
>_______________________________________
>Don Tuite  Technical Writing Supervisor
>KVO                    Public Relations
>650/919-2030 v        don_tuite@kvo.com
>650/919-9976 f       http://www.kvo.com
>_______________________________________
>
>--
>FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
>Submissions:              tentec@contesting.com
>Administrative requests:  tentec-REQUEST@contesting.com
>Problems:                 owner-tentec@contesting.com
>Search:                   http://www.contesting.com/km9p/search.htm
>
>
>
--------------
   \\\@///  
     ·    · 
       o      
-------------
Piotr Tomczak           Ham call: la9hfa
Nera ASA
E-mail job: pito@satcom.nera.no         E-mail home: la9hfa@qsl.net


--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm