[TenTec] Replies for Omni VI+ Service

Steve Baron - KB3MM SteveBaron@starlinx.com
Wed, 20 Oct 1999 21:00:35 -0000


Is't there a problem though ?

Working split and keying at a decent speed would require the counter to make
a measurement prett fast - or maybe simply not measure while sending.

Lets see - if I was on the XMIT frequency for 0.1 seconds, what kind of
frequency read out resolution would I have ?


----- Original Message -----
From: <JimN0OCT@aol.com>
To: <aa8ve@juno.com>; <tentec@contesting.com>
Sent: October 20, 1999 8:30 PM
Subject: Re: [TenTec] Replies for Omni VI+ Service



In a message dated 20-Oct-99 14:20:03 Central Daylight Time, aa8ve@juno.com
writes:

> Too bad we can't have a readout that can be switched to a real time freq.
>  counter. This could be used to aline the rig as well as tuning. I think
>  the new Elecraft (spl?) qrp rig has something like this in it so I know
>  it can be done.

A la the TR7.  Built in freq counter from 0-150 MHz, with external input.
That would be nice in any TT rig!

73, Jim
NĜOCT

--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm




--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm