[TenTec] OmniC

[Michael O. Hyder]

I called about that problem and Garland said they would provide a bent
spring washer to put in the rear of the resonate control shaft.  I think it
even came with instructions for where to put it.  He sent a couple of those
washers to me (now I need three).

But before I put it in, another fellow on this reflector said he called them
and they suggested he loosen some screws and then squeeze something or pry
it out (not sure which) while retightening the screws.  At the time, I
didn't have the Omni-C out of storage.  Now that I do, I wish I had done
something before now.  I will scope out the assembly and report back.

The felt pad is not a bad idea, but Ten-Tec felt pads are way too big.

73 de Mike N4NT@charter.net

----- Original Message -----
From: "John/K4WJ" <k4wj@att.net>
To: "Ed & Edna" <edn4pk@vol.com>; "TenTec" <tentec@contesting.com>
Sent: Monday, February 21, 2000 8:28 PM
Subject: Re: [TenTec] OmniC


>
> At 06:43 PM 2/21/00 -0500, Ed & Edna wrote:
>
> >What is the correct way to tighten up the Resonate control ??
> >Ed   W3NR
>
> Ed,
>
> When John McCoy was the Omni C expert at TenTec, he told me to slip a
small
> felt pad behind the Resonate control.
>
>
> 73..de John/K4WJ



--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm