[TenTec] Thanks

[William Mansey]

Thanks for the suggestions.  I will check the baud rate and the wiring.  One
response mentioned connecting pin 2 to pin 2 and 3 to 3 but this is not what
the manual indicates.  It indicates that they should be 2 to 3 and 3 to 2.
There is only one other wire which goes from pin 5 of the db-9 to pin 7 of
the db-25.  There is a jumper between pin 4 and 6 on the db-9 connector.
The program I am currently trying is called TRX Manager.  This works with my
Kenwood TS-570DG and a standard db-9 to db-9 cable.  I will check the
settings and try again.  The problem is not with the com port so it must be
either a wiring problem or a problem with baud rate.  I do appreciate the
responses.  I hope to get this working but, even if I am unsuccessful, I
will continue to enjoy using the Omni the quaint old fashioned way - - -
with "real" knobs and buttons!!!
    YES - I am also getting multiple messages.  Perhaps someone (or
something) is taking this reflector thing too far!    Thanks again;  BILL



--
FAQ on WWW:               http://www.contesting.com/FAQ/tentec
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com