[TenTec] d-104 and omni V

[w8au@sssnet.com]

The D-104 likes a high Z load of about 4.7 megohms, (to achieve proper 
response) and you don't get this with newer TenTecs and solid state 
rigs.  This has been addressed before, but I can't tell you where to look 
at the moment.   One obvious way would be to use an emitter-follower 
circuit to go from hi to lo Z.

Try the "hints and kinks" publications from ARRL......

73,

Perry  w8au

--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm