[TenTec] Pegasus remote operation

[w8au@sssnet.com]

Hello gang:

I need some advice from those who have used successful remote setups with 
the Peg.

The scenario is this:     Wish to install the Peg (that I do not have 
yet)  at a remote tower site, and keep the computer at the shack.

Since the serial connection is at 56k, I would need to use a wideband 
duplex connection, I assume.....

In other words, I would have to split the TX/RX data into a "4-wire" 
arrangement for use on a simultaneous xmit/receive  UHF or Microwave link 
at wideband deviation.

Has anyone done this?   Is there a simpler way?  What about phase delays on 
the 4-wire duplex link?
Since the link would be wideband, could a modem simpler than the 
quadrature-phase-amplitude modulation types be used?

Appreciate any and all suggestions...

Tnx & 73,

Perry     w8au


--
FAQ on WWW:               http://www.contesting.com/FAQ/tentec
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com