[TenTec] Jupiter Suggestions

Jack Malone malonej@c2i2.com
Thu, 5 Apr 2001 14:12:32 -0700


Jim:
I forgot to give you the RS part #'s
32-1031
Page 200 in 2001 Catalog
73's
Jack, W7EJJ
--
----- Original Message -----
From: <pywacker@fuse.net>
To: "Jack Malone" <malonej@c2i2.com>
Sent: Monday, April 02, 2001 6:45 PM
Subject: Re: [TenTec] Jupiter Suggestions


> Jack, thanks for info.
>
> 73 de KE4WY Jim
>
> ----- Original Message -----
> From: "Jack Malone" <malonej@c2i2.com>
> To: <pywacker@fuse.net>
> Cc: "Ten-Tec" <tentec@contesting.com>
> Sent: Monday, April 02, 2001 9:40 PM
> Subject: Re: [TenTec] Jupiter Suggestions
>
>
> > Hi Jim:
> >
> >     My biggest complaint with the Jupiter is the speaker output, they
use
> a
> > push/pull output that cannot be grounded. Cheap way of doing it, Drake
did
> > the same thing on their SW-8. This negates using my external speaker
which
> > has two input positions on it. I use one input for my JRC NRD545DSP
> Receiver
> > and would like to use the other for the Jupiter but cannot. I bought a
> > $19.95 speaker from Radio Shack, in the meantime I'm going to try some
> > isolation methods and try to isolate the Jupiter speaker out. Capacitors
> > will not work.
> >
> >     I use a transmit bandwidth of 2550 or 2400 just to keep my sig from
> > QRMing adjacent freqs.
> >
> >     Mic gain depends on mic. I use a Radio Shack Pro 301 dynamic studio
> mic
> > with gain at 100% and R72 on the logic board set full gain. When I use
the
> > TenTec 701 hand mic I set the mic gain to about 5 to 20%
> >
> >     I use 60% processor.
> >
> >     I run about 400Watts PEP with a Amp.
> >
> > 73's
> > Jack, W7EJJ
> > w7ejj@arrl.net
> >
> > ----- Original Message -----
> > From: <pywacker@fuse.net>
> > To: "TenTec Mailing List" <tentec@contesting.com>
> > Sent: Monday, April 02, 2001 1:31 PM
> > Subject: [TenTec] Jupiter Suggestions
> >
> >
> > >
> > > Any suggestions on a good external speaker for the Jupiter? The
internal
> > > speaker is surprisingly quite good.
> > >
> > > Also on phone I would be curious to know the transmit bandwidth,
> > processing
> > > or not, typical mic gain settings and microphone Jupiter users are
> using.
> > > If you would share this in private email I would appreciate this info.
> > >
> > > 73 de KE4WY Jim
> > >
> > >
> > >
> > >
> > >
> > >
> > >
> > > --
> > > FAQ on WWW:               http://www.contesting.com/FAQ/tentec
> > > Submissions:              tentec@contesting.com
> > > Administrative requests:  tentec-REQUEST@contesting.com
> > > Problems:                 owner-tentec@contesting.com
> > >
> > -
> > end
> >
>
>
>


--
FAQ on WWW:               http://www.contesting.com/FAQ/tentec
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com