[TenTec] New TenTec release of Pegasus software with AM transmit

[Jerry Harley]

The auto setup, set the power to 23 and my meter reads peaks of 30, no
carrier though ( i'm guessing none needed).  I did listen to my signal
and adjusted the power up, and as i reached 40 I heard distortion. Jerry

pywacker@fuse.net wrote:
> 
> Carl, just checked the Jupiter in the Pegasus mode and it shows 22 watts on
> my RF Appl VFD wattmeter.
> 
> 73 de KE4WY Jim
> 
> ----- Original Message -----
> From: "Carl Moreschi" <n4py@earthlink.net>
> To: "tentec" <tentec@contesting.com>
> Sent: Friday, April 06, 2001 4:55 PM
> Subject: [TenTec] New TenTec release of Pegasus software with AM transmit
> 
> >
> > Has anyone had any success with the new TenTec software and AM
> > transmit?  I tried it and can only get about 1 watt output.  Two others
> > have tried it and claim the same thing.  TenTec says they are not aware
> > of a problem.
> >
> > Carl Moreschi  N4PY
> > Franklinton, North Carolina
> > n4py@earthlink.net
> >
> >
> > --
> > FAQ on WWW:               http://www.contesting.com/FAQ/tentec
> > Submissions:              tentec@contesting.com
> > Administrative requests:  tentec-REQUEST@contesting.com
> > Problems:                 owner-tentec@contesting.com
> >
> >
> 
> --
> FAQ on WWW:               http://www.contesting.com/FAQ/tentec
> Submissions:              tentec@contesting.com
> Administrative requests:  tentec-REQUEST@contesting.com
> Problems:                 owner-tentec@contesting.com

--
FAQ on WWW:               http://www.contesting.com/FAQ/tentec
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com