[TenTec] Flash Upgrade

[Jim FitzSimons]

John, you can not open it with the radio on. 
Exit the software and turn the pegasus off. The firmware
only can be loaded when the RX led is flashing.
Regards, Jim FitzSimons W7ANF

----- Original Message ----- 
From: "John Watson" <kc4tbh@zoomph.net>
To: "Ten-Tec at Contesting.com" <TenTec@contesting.com>
Sent: Sunday, February 04, 2001 17:41 PM
Subject: [TenTec] Flash Upgrade


> 
> Ok sportsfans, I have d/l'd the flash upgrade for firmware to the
> pegasus. I have the following questions, and I hope that someone is
> online to answer them.
> 
> First, I am using version 1.40 of N4PY's software Now to the questions
> 
> 1. I have installed it to it's own folder: C:\TTFlash, but when I open
> it, with the radio on and using the TEN -TEC version of software OR
> Carl's version 1.40 I get an error saying "communication with the radio
> has failed. Since a programming function was interrupted, the radio may
> not function properly.THen it says to check the connections and power
> and try again.
> 
> 2. Has anyone else had this problem and if so how did you resolve
> it.....Boy I hope I didn't screw this radio up.



--
FAQ on WWW:               http://www.contesting.com/FAQ/tentec
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com