[TenTec] RF in audio

[VE1BN@aol.com]

Hi Ken -

You asked why only Ten-Tec has an RF problem?

Have no idea why you should  - -  if you have a real RF ground 
system. Then you should have no RF feedback!  But maybe you 
don't have a decent ground,  and I don't mean a ground rod 
stuck in the ground.  

I live in a highrise , run anything up to the full limit ... all bands 
with my Titan if I choose. I have never had a single indication
of RF getting into my Paragon, or OMNI 6+.  My station ground is 
a single copper tube fastened behind the operating table, with 
individual ground straps to each piece of gear, including power 
supplies, going to it. This main ground tube is connected to the 
building ground which is a maze of copper hotwater radiator pipes 
throughout the building.  No BCI, TVI, whatever, after 20 years 
of operating in this QTH,  and I am 7 floors up from ground level.

Have never had a wisp of RF feedback here,  or in my former QTH 
in VE2 land. The best friend a ham station can have is its solid RF
ground system.  A great many don't realize the real value of one.

Don't blame Ten-Tec gear.   None better than the OMNI 6+ for the 
serious amateur radio CW or SSB DXer.    

But then again,  you probably do have a good ground!!   Good luck, 
am sure someone will have a much better suggestion to solve your 
problem than this offering.

73  -  Don  VE1BN

--
FAQ on WWW:               http://www.contesting.com/FAQ/tentec
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com

--
FAQ on WWW:               http://www.contesting.com/FAQ/tentec
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com