[TenTec] CW-offset adjustment OMNI6+

[Carl Moreschi]

The pitch should change in your receiver, but your transmitted signal should
NOT
change.

Carl Moreschi  N4PY
Franklinton, North Carolina
n4py@earthlink.net
----- Original Message -----
From: <DK2GZ@aol.com>
To: <tentec@contesting.com>
Sent: Friday, May 04, 2001 6:30 AM
Subject: [TenTec] CW-offset adjustment OMNI6+



Hello,

think my cw offset adjustment doesn´t.

Hooked up a second receiver and set the offset to 400 Hz and
listen on the second rx, then set the offset 990Hz and listen again,
the signal was still present on the same qrg on the second rx.
I thought the signal should be 590 HZ up or down now, but is still
on the same frequency on the second rx.


73 de Harry, DK2GZ

--
FAQ on WWW:               http://www.contesting.com/FAQ/tentec
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com



--
FAQ on WWW:               http://www.contesting.com/FAQ/tentec
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com