[TenTec] Corsair II digital readout

[Bob, WB2VUF]

I spoke too soon: The "obsolete chip that I referred to is in the
Corsair I. Looks like Corsair II used a different chip.

			Bob WB2VUF

"Dr. Gerald N. Johnson, electrical engineer" wrote:
> 
> Check the 5 volt power to the digital readout microprocessor and replace
> any electrolytic bypass capacitors in the module. Try the keyer, its in
> the same computer chip. Tighten the board mounting screws to be sure the
> grounds are solid.
> 
> 73, Jerry, K0CQ
> 
> --
> Entire content copyright Dr. Gerald N. Johnson. Reproduction by
> permission only.
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec