[TenTec] Omni VI volume control

[Jorge A Mejia]

Hi all 

When I move the volume control of my two months old Omni VI Plus, either
up or down  there are certain points where I get a bad "crushing" noise
which is annoying specially while wearing headphones .Does anybody have
any sugesstions other than  Replacing the pot? I tryed to expose the
center shaft of the pot to spray it with contact cleanear (from the
front panel) but all I could do was to take  the center plastic knob off
( held by a hex screw) ; I could not remove the gray plastic iner ring 
(the rf gain knob) Has anyone tryed to replace the pot, I would very
much appreciate any suggestions.

Thank you

Jorge HK4CZE