[TenTec] Fluid motion antenna

[wb4mnf]

All H.F. I know of, that aren't wire, have hollow elements.
Much stonger for the same amount of material.

It's a steal when you consider the cost of monoband antennas and the
machine to turn them and the extra tower strength required...

Almost instant long to short path with back to front switch just
by small element adjustment. Minimal feed line loss and maximum
efficiency on any freq in range...

I like it!

-bob
WB4MNF
full wave 80m V plane loop Atlanta, Hustler 4BTV Honolulu

Stuart Rohre wrote:

> OK, thanks, then it does have bigger wind load than a conventional Yagi to
> allow for the hollow element, I would think.
> Seems like a lot of effort that could have been done by fixed linear
> decouplers, (stubs).
> 73,
> Stuart K5KVH
> 
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 
> 
>