[TenTec] Latest Jupiter firmware update.

[Robert & Linda McGraw K4TAX]

I seem to find that most computers require re-booting any time one loads a
new operating system.  This one seems to be no different.  There's things
that go to non volatile RAM the need to be cleaned out and thus re-loaded.

73
Bob K4TAX

----- Original Message -----
From: "Winston F Jones" <winjones@ix.netcom.com>
To: "William F Mansey WA2PVK" <res0wsci@verizon.net>;
<TenTec@contesting.com>
Sent: Thursday, April 04, 2002 9:48 PM
Subject: Re: [TenTec] Latest Jupiter firmware update.


> I had this same thing happen on one of the earlier Ten-Tec firmware
updates.
> After I reloaded the same update again, it worked O.K. I must have reset
it
> correctly the second try.
> 73, Winston  K4CWQ
>
> ----- Original Message -----
> From: "William F. Mansey; WA2PVK" <res0wsci@verizon.net>
> To: <TenTec@contesting.com>
> Sent: Thursday, April 04, 2002 20:36 PM
> Subject: [TenTec] Latest Jupiter firmware update.
>
>
> > I downloaded and installed the new update (1.17) and found that my
Jupiter
> > did not transmit!  Press the tune button - nothing!  Use the PTT
switch -
> > nothing!  I reverted back to the previous firmware and all is okay
again.
> > Anyone else experience this?   73;  Bill
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>