[TenTec] Paragon VFO Problem

[Phil Chambley, Sr.]

Sounds like the encoder shaft is binding in its bushing.  Remove the knob
and put a drop of WD40 on the shaft  so it runs down ito the bushing.  Just
a drop.  73.

Phil Chambley, Sr. K4DPK
-----Original Message-----
From: Steve Ellington <n4lq@iglou.com>
To: geraldj@isunet.net <geraldj@isunet.net>; w5cia@arrl.net <w5cia@arrl.net>
Cc: tentec@contesting.com <tentec@contesting.com>
Date: Saturday, August 24, 2002 5:34 PM
Subject: Re: [TenTec] Paragon VFO Problem


>But it's a Paragon. No PTO. Has a hole counter instead.
>
>Steve Ellington N4LQ.
>----- Original Message -----
>From: "Dr. Gerald N. Johnson, electrical engineer" <geraldj@isunet.net>
>To: <w5cia@arrl.net>
>Cc: <tentec@contesting.com>
>Sent: Saturday, August 24, 2002 10:43 AM
>Subject: Re: [TenTec] Paragon VFO Problem
>
>
>> Standard Tentec VFO wear. Needs a rebuild. Kit from TenTec about $23,
>> takes about 3 hours to do the first one. Sometimes cleaning and
>> regreasing works, but my CorsairII had a very worn ball reduction
>> section that was replaced by the one from the rebuild kit and it works
>> super now.
>>
>> 73, Jerry, K0CQ
>> --
>> Entire content copyright Dr. Gerald N. Johnson, electrical engineer.
>> Reproduction by permission only.
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>