[TenTec] BFO Alignment Omni D Freq?

[Steve]

I took a look at the Argosy manual and they both use the same circuitry and
the same procedure to align the carrier oscillator. If they got the Argosy
one wrong then I have to assume as you did that they got the Omni-D one
wrong too.  Thanks for the tip..

Steve
----- Original Message -----
From: "Clark Savage Turner" <csturner@slonet.org>
To: "Steve" <sswhite@mchsi.com>
Sent: Tuesday, December 10, 2002 8:02 PM
Subject: Re: [TenTec] BFO Alignment Omni D Freq?


> I think the manual is in error on this.  I recall it was in error on the
> Argosy and think it may have been the same for the OMNI.  I would call
> Ten Tec and ask for the right numbers, I recall having this problem
> myself.
>
> Clark
> WA3JPG
>
> On Tuesday, December 10, 2002, at 02:31 PM, Steve wrote:
>
> > Does any one know the correct freq that the BFO's should be set to when
> > aligning the Omni-D?  I have tried the method outlined in the manual
> > and it
> > seems a bit of a difficult way and can lead to some errors if you don't
> > have
> > the right test equipment.
> >
> > I have tried that method with limited results and want to try just
> > setting
> > the BFO freqs with a counter and see if that will work.
> >
> > Some of you experts with the Omni-D probably know the answer to
> > this...Any
> > help or comments would be useful.
> >
> > Steve
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>