[TenTec] Jupiter 1.14 Firmware Problem(s)

[J. Duffy Beischel]

I just did the 1.14 update and it works fine.  A big thank you to Ten Tec on this one. The 
reduced power function on tune is what I have been asking for.  It works fine.  I went 
from SSB (full power) to tune (about 20 watts or so) and then back to SSB and it is at full 
power again.  I love it.  Thank you TT!!!

Duffy - WB8NUT

2/7/02 7:01:20 PM, WmLB@prefer.net wrote:

>Yes.. that would seem to be the case all right.
>
>I certainly have no issue with the "Tune" function reducing power. 
>It's probably a good innovation.. But.. your right.. it should not be 
>a "sticky" function in the processor and one should not have to do 
>anything (like pressing the "power" button) to restore set power 
>levels.
>
>The guy I talked to at Ten-Tec said the software guy was home with 
>the flu, so it looks like it might be a day or more before they 
>resolve it.
>
>Bill, W6WLB
>
>
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>



______________________________________________________________________
J. Duffy Beischel - Amateur Radio WB8NUT

Member of: ARRL, NRA, Kiwanis, Republican Party, Masons, and Shriners
and the vast Right Wing conspiracy to get the Clintons

"If the government owned all the guns, would we still be a free people?"
______________________________________________________________________