[TenTec] Jupiter AM Operation.
Dave McClafferty
ve1adh@accesswave.ca
Sat, 9 Feb 2002 23:26:23 -0400
The speech processor will cause overmodulation in the AM mode at normal mic
gain levels in the pegasus. I assume it is the same in the Jupiter
Dave, VE1ADH
----- Original Message -----
From: <WmLB@prefer.net>
To: <tentec@contesting.com>
Sent: Saturday, February 09, 2002 9:48 PM
Subject: [TenTec] Jupiter AM Operation.
>
> After owning my Jupiter for several months, I got around to trying it
> on AM yesterday. The reports were that my audio was very distorted...
> perhaps due to over-modulation.
>
> In the prior firmware release (1.12) when I tried the AM-AUTO-SET
> procedure described in the addendum in my manual, the power out
> indication would increase and decrease but would never return to
> receive mode until I pressed the "Tune" button again.
>
> With the new 1.16 release, pressing the "Tune" button does not
> trigger the same behavior at all. I do get a steady indication of 16
> to 20 watts out. I think this is now the desired behavior of the tune
> function, which limits the output during the tuning process. But...
> it would no longer seem to relate to any automated power level
> setting while in AM mode. Of course, as I said previously, I could
> never get that power level "hunting" behavior to cease in the earlier
> firmware releases anyway.
>
> I would like to know, if anyone is successfully working the AM mode
> with their Jupiter and if so, where do you have the "AM Drive"
> adjusted to. It appears that setting my AM Drive to about 35% gets me
> an unmodulated carrier of about 25 watts. Does that sound right??. I
> have the Mic Gain at about 50% which is where I would normally have
> it for SSB operation.
>
> Today, with the Santa Ana winds and the accompanying high noise
> levels, I have been unable to hook up with anyone, but I would like
> to know if I am on the right track .. and if my Jupiter is reacting
> the same way as everyone elses.
>
> Bill, W6WLB
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>