[TenTec] triton 544

[Mike Hyder -N4NT-]

Yes, use a good contact cleaner on the bandswitch contacts.  The guys lately
have been using Deoxit.  If you properly care for the 544, it will outlive
you even if you're a kid.  But if it were mine, I'd send it off to Garland
at Ten-Tec and have him make it as new.

Your readout shifting may be because your Offset is turned on?  Some rigs
have an internal pot that balances the offset when it is turned off.  I had
an Astro 102 rig once with a dirty internal pot.  It was not stable until I
cleaned that pot.

73, Mike

**No outgoing Email is screened by Norton Antivirus**

----- Original Message -----
From: "David Heintzleman" <pstrdave@kdsi.net>
To: <tentec@contesting.com>
Sent: Monday, May 13, 2002 8:05 AM
Subject: [TenTec] triton 544


> my aging 544 triton transceiver -  having an intermittent problem with
> bandswitch - while in use, at times readout goes to 1.000.0 and output
> falls  - sometimes receiver stops, sometimes not -
> repositioning bandswitch solves problem.
>
> is this a case of some service needed on bandswitch or is my dear old
> set up (544, matching vfo, keyer, ps) just getting too old?
> Also, digital display very erratic on transmit (cw) swinging +400 khz, -
> 50 khz while keying -
> any suggestions
> Dave K8BBM
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>