[TenTec] Omni 6 sidetone.

[Paul Christensen]

I don't have my schematic handy, but start by unplugging Plug 52 on the IF/AF Circuit Board and tie-wrap it out of the way.  That's
right...the plug just floats in the cabinet.   I'm pretty sure its Plug 52, but confirm that it is wired back to the CMOS 4066 quad
switching chip.

Paul, W9AC
 
> ----- Original Message -----
> From: "Mike" <zl1mh@nzart.org.nz>
> To: "tentec reflector" <tentec@contesting.com>
> Sent: Tuesday, November 05, 2002 9:40 PM
> Subject: [TenTec] Omni 6 sidetone.
> 
> 
> > Now I've got my Omni 6 in action again, I'd like to do something to either
> > cure, or alleviate, the clicky/thumpy sidetone which has always been a
> > feature of my Omni 6, from new.
> > Thump/Click problem exists even with power-out set to minimum, at all
> > settings of sidetone level & with both the internal & external keyer, so
> > guess its audio-related rather than RF leakage.
> > Anyone on the list had this problem?
> > Any fixes?
> > 73 de Mike, zl1mh
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>