[TenTec] Omni VI+ and Heil mics

[Robert & Linda McGraw K4TAX]

Stuart:

I agree totally with your comments.

With one point of clarification:
Most of us have shacks too far from RF ground.  Keep in mind that RF ground
is based on electrical wavelength.  Hence a ground that is 1/4 wavelength
produces the highest voltages at one end.  Example: on 20M 1/4 wave is some
16ft. and is a worst case situation for an effective RF ground on 20M.

I use balanced feedline on a center fed 256 ft. wire and operate 160M - 10M
and have NO RF ground on the rig or tuner.  There's no RF in the shack
either.  The only ground is the AC 3rd pin ground for safety purposes.  My
station is on the 2nd floor of a wooden frame house.  Under these
conditions, the Omni VI+ driving the Centurion amp doesn't cause a problem.
Clearly my balanced feed system works and the center of the antenna is 55 ft
above ground.  Also, there is no telephone interference or TVI either.

73
Bob K4TAX

----- Original Message -----
From: "Stuart Rohre" <rohre@arlut.utexas.edu>
To: "Rob Atkinson K5UJ" <k5uj@hotmail.com>; <tentec@contesting.com>
Sent: Wednesday, October 09, 2002 9:50 PM
Subject: Re: [TenTec] Omni VI+ and Heil mics


> Rob, I think many of those who report hum problems need to look to their
> grounding practices, since you demonstrate none of the problems.  There is
> no great difference in the audio circuits of the models, as far as it has
> been told here.
> Many expect to run with Windom type, (unbalanced) antennas or even end fed
> or random wires and then are surprised they have RF in the shack.  Most of
> us have shacks too far from earth to have effective RF grounds to an earth
> rod only.
> 73, Stuart K5KVH
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>