[TenTec] Omni VI sub receiver

[Gert Meinen]

Mark, If you add a connector (BNC or similar) above the AUX  RX  Antenna
connector on the back of the Omni VI,  you can wire  it to the junction
of C6,D5 ,D6 and L3 through a 0,1uF capacitor and your in business. 73,
Gert PA3AAV.
----- Original Message -----
From: Mark Erbaugh <mark@microenh.com>
To: <tentec@contesting.com>
Sent: Monday, September 16, 2002 6:40 PM
Subject: [TenTec] Omni VI sub receiver


> Is there a way to connect a receiver to an Omni VI (or VI+) so that it
gets
> the same Rx signal as the Omni, but is protected from the Tx output of
the
> Omni?  On the Omni V, the Rx antenna could be used for this, but , I
think
> that is not the case with the Omni VI.
>
> 73,
> Mark
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec