[TenTec] Orion receiver audio gone after 'TUNE' button pressed

[Michael A. Newell, WB4HUC]

Well, it seems a master reset cures
the problem. I just hadn't done that
after I installed 1.337. I reset the radio
a few minutes ago and that cured it.

Thanks,

Mike - WB4HUC
Austin, TX
http://home.austin.rr.com/mjnewell/station2.html


----- Original Message ----- 
From: "Phil Howlett" <w9xx at ivwnet.com>
To: <tentec at contesting.com>
Sent: Sunday, April 13, 2003 8:58 AM
Subject: Re: [TenTec] Orion receiver audio gone after 'TUNE' button pressed


> Same version; this radio doesn't do that.
> 
> W9XX
> 
> 
> ----- Original Message ----- 
> From: "Michael A. Newell, WB4HUC" <mnewell1 at austin.rr.com>
> To: "tentec" <tentec at contesting.com>
> Sent: Sunday, April 13, 2003 8:34 AM
> Subject: [TenTec] Orion receiver audio gone after 'TUNE' button pressed
> 
> 
> Three times in a row now I've turned the radio on,
> and the first thing I've done is press the TUNE button
> for a few seconds. When I press it again to turn it
> off, neither receiver audio can be heard.
> 
> All the other functions work: menus, antenna buttons,
> vfo buttons, etc., there's just no audio from either
> receiver.
> 
> I'm using version 1.337 of the firmware, but this
> problem may not be related to a particular firmware
> version.
> 
> Can anyone else check this out? 
> 
> Just turn the rig off (or off then back on) then press
> the TUNE switch to activate the transmitter. 
> 
> Then press TUNE again to turn off the transmitter
> and see if either receiver audio is there or not.
> 
> Thanks.
> 
> 73,
> 
> Mike - WB4HUC
> Austin, TX
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>