[TenTec] My second Ten Tec is a Triton IV.

[Mike Hyder -N4NT-]

Lew, probably any handbook has a schematic of a crowbar circuit.  It would
consist of an SCR and a zener diode, along with a fuse.  In principle, the
SCR is across the load end of the fuse so that when the supply voltage
exceeds that set by the zener, the SCR fires and draws enough current to
blow the fuse.  This protects the load (rig) from overvoltage.  Without it,
a shorted pass transistor would cause about 25 volts to be applied to the
rig.

Mike N4NT

----- Original Message -----
From: <LJL160 at aol.com>
To: <tentec at contesting.com>
Sent: Thursday, April 24, 2003 1:33 PM
Subject: Re: [TenTec] My second Ten Tec is a Triton IV.


> IS THERE A SCHEMATIC OF THE CROW BAR CIRCUIT FOR THE POWER SUPPLY? I
ASSUME
> ONE WOULD NEED HOMEBREW IT UNLESS SOMEONE HAD ONE THEY NEVER INSTALLED?
73S
> LEW