[TenTec] Jupiter can't hear post-processing audio

[John]

Dosen't that also make it impossible to hear the changes you make to the
transmit audio via the radio ?  John
----- Original Message -----
From: <jsb at digistar.com>
To: <tentec at contesting.com>
Sent: Wednesday, December 17, 2003 9:51 AM
Subject: [TenTec] Jupiter can't hear post-processing audio


> On Tue, 16 Dec 2003 KD7EFQ at aol.com wrote:
>
> > When you have 8-10 or more chain stores and dealerships dealing only the
> > "BIG" 3 or 4 names, and not stocking a Ten Tec next to them, the Ten Tec
> > will probably not cross peoples minds and go totally unconsidered. Since
> > Ten Tec is factory direct, Chain stores & dealerships have no commission
> > to make and of course aren't going to push the rigs they won't make
> > money off of, regardless if it's a performer or not.
>
> A local ham in my neck of the woods works for HRO and is a real good
> salesman for YaeComWood gear - if it weren't for me there would be no
> mention of Ten-Tec unfortunately.
>
> Some of these guys continue to rave on about old Kenwood stuff despite the
> better offerings available.  Never ceases to amaze me.
>
>
> On the other hand...  One thing that I've heard a number of times is the
> inability to monitor audio output through headphones.  Yes, I can hear the
> mic preamp but the Jupiter does not provide a means to listen to the
> post-processing stage as it is pushed out the antenna - this is a serious
> problem to 99% of the sideband users I talk to.  Makes it a bit difficult
> to adjust speech processing levels...
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec