[TenTec] Installing batteries in the Jupiter?

Mark Erbaugh mark at microenh.com
Mon Dec 22 23:00:35 EST 2003


Jeff,

I don't think the Jupiter or the Pegasus like voltages much below 13.8v.

Mark

----- Original Message ----- 
From: <jkelly at verizon.net>
To: <tentec at contesting.com>
Sent: Sunday, December 21, 2003 8:56 AM
Subject: [TenTec] Installing batteries in the Jupiter?


> After looking at the inside of the Jupiter, I was wondering if there is
enough room to place 897 (or other) batteries inside the Jupiter to provide
portable 12v power.  The manual says 1.5 amp draw on receive - probably not
the best radio for this use. Power would need to be dropped to 10 - 20
watts.  Nevertheless, reveiwing the pics on N9VV site shows a lot of room in
the radio.  Perhaps the spare jack could connect to the pack and allow
charging and a jumper to the 12volt input connector would provide the power
when needed?
>
> http://www.n9vv.com/Images/jupiter-13.jpg
> http://www.n9vv.com/Images/jupiter-14.jpg
>
> Any thoughts?
>
> Jeff
> KT2K
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>



More information about the TenTec mailing list