[TenTec] Omni VI encoder

[Mark Erbaugh]

Anthony,

I think the Omni VI is the same. I know a several of the folks here are
replacing the knobs on their Jupiters with the knobs for the Orion (direct
from TenTec). They seem to be pleased. Maybe you could use one of those
knobs (or maybe someone would give you the original Jupiter knob that
they've replaced.

Mark

----- Original Message -----
From: "Anthony Bowyer" <adb1x1 at yahoo.com>
To: <tentec at contesting.com>
Sent: Thursday, February 20, 2003 11:38 AM
Subject: [TenTec] Omni VI encoder


> Mark,
>   I was able to use a small mechanical encoder that
> came from an Icom IC-728 on my Omni V. I had to pull
> the encode lines high with resistors, but it worked
> fine. I couldn't detect any problems with missed
> pulses, etc. I assume the Omni VI arrangement for the
> 301 is the same. I've been looking for a decent knob
> that doesn't cost as much as the encoder!
>
> Anthony
>
> =====
> NT4X
>
> __________________________________________________
> Do you Yahoo!?
> Yahoo! Tax Center - forms, calculators, tips, more
> http://taxes.yahoo.com/
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>