[TenTec] Pegasus power plug??

[denton]

Well, on my vernable Corsair II the power plug mod was easy...I went to rat
shack and got a couple of those molex high amperage plug and wired it up
myself....I use a homebrew power supply, and the Corsair's circut breaker so
the job was easy.
I am not too sure abt the Pegasus thou, as its resident plug is soldered
direct to a pc board. Will play around with this winter.
The older Delta I used to have, and ran full bore rtty with, fried the
originial plug! Too much current!
----- Original Message -----
From: Mike J Maloney <ac5p@juno.com>
To: <denton@oregontrail.net>
Cc: <tentec@contesting.com>
Sent: Friday, January 17, 2003 5:22 PM
Subject: Re: [TenTec] Pegasus power plug??


> Denton,  Am not at all surprised, as the pin diameter and surface contact
> at the connector interface is marginal.  Would be better to parallel up
> pins or upgrade to better connector.   Please share with us what you went
> to for something "beefier"?
> Mike, AC5P
>
> On Fri, 17 Jan 2003 11:23:32 -0800 "denton" <denton@oregontrail.net>
> writes:
> > Hi all...
> > I have recently acquired a used Pegasus and am wondeing if any of
> > you have problems with the power plug.
> > I have had to replace the stock plug with something beefier on both
> > my Delta and Corsair II since they would get a bit warm and cause a
> > voltage drop.
> > I run a lot of digitial modes and rtty....thanks in advance de
> > Denton WB7TDG
> >
> >
> > --- StripMime Report -- processed MIME parts ---
> > multipart/alternative
> >   text/plain (text body -- kept)
> >   text/html
> > ---
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>