[TenTec] Omni 6 plus schematic

[K3BU at aol.com]

In a message dated 7/9/03 6:18:19 PM Eastern Daylight Time, 
w6wqc at dslextreme.com writes:

> Does anybody have any info on how to adjust R27 and R31 on the 5-5.5 mhz PLL
>  board?
>  
>  The serial input from the microprocessor comes into pin 1, U3 on the 5-5.5
>  PLL board. Where does this come from? I can not find a number 87 connector
>  on the Logic board.
>  

On the logic board schematic, top left corner, 1" from the left, 2" from top 
there is 4 pin connector, unmarked, it is 87 with signals marked from the top: 
CLOCK, DATA, EN and Gnd connection.

>  Does the rotary encoder connect to connector 98 on the Logic board?
>  

Yes, shown on the wiring diagram (last schematic)

GL, Yuri, K3BU