[TenTec] RE: Argo V low output? - SOLVED

[Rick Williams]

First Paul called back and after a few minutes it became evident that remote
troubleshooting would likely not work this time (thanks for your efforts
Paul).  So I was almost ready to wrap the Argo V up and send it south.
However, I had all those schematics and a scope so I thought I'd do a little
troubleshooting on my own.

It became evident that the waveform on the bands with low output was pretty
ugly and on 80 it wasn't all that good but not as bad as the others.  A few
voltage checks and poof!  Yes poof - I blew the 7.5 amp fuse be
inadvertently shorting VCC to ground.  UGH!!

I replaced the fuse and surprise - all the problems went away.  It looks
like I was getting enough of a voltage drop across the fuse to cause a
problem.  Given that, it looks like a "battery booster" is in my future!

Anyway I'm back in business!

73,

Rick
VE7ASR

Web site:  http://www3.telus.net/ve7asr


>  -----Original Message-----
> From: 	Rick Williams [mailto:rick.williams at telus.net]
> Sent:	July 24, 2003 11:38
> To:	TenTec List (E-mail)
> Subject:	Argo V low output?
>
> Rats!  I've been playing with the Argo and having a ball but
> this morning that changed!
>
> Today I have full output on 80 but little to none on the
> other bands.  (160 m and 60 m have about 10 watts and 20 m
> about 4 watts.  The rest are less than 2 watts)  I can only
> get an ALC indication on 160 through 60 m.  All readings are
> with a stable power supply into a dummy load.
>
> In all cases the Argo draws approximately 8 amps at full
> output setting in transmit.  The receiver functions perfectly
>
> I've done a Master Reset but no joy.  I have a call into the
> mother ship but it has not yet been returned.
>
> Any thoughts from the collective wisdom on the reflector?
> Would a reload of the software (Version 1.07) be worthwhile?
>
> Thanks,
>
> 73,
>
> Rick
> VE7ASR
>
> Web site:  http://www3.telus.net/ve7asr
>
>
>