[TenTec] Q: Triton 249 Noise Blanker

[Mike Hyder -N4NT-]

It is possible that one needed to remove a jumper prior to installing the
noise blanker.  I'm pretty sure you had to do that with the CW filter, and
logic indicates that you would need to break the signal path to install the
blanker in the rig.  If the jumper wasn't removed, perhaps you are getting
some sort of feedback through the blanker.

73, Mike N4NT

----- Original Message -----
From: "jdanter" <jdanter at mail.i-america.net>
To: "TenTec List" <tentec at contesting.com>
Sent: Monday, June 16, 2003 8:41 PM
Subject: [TenTec] Q: Triton 249 Noise Blanker


> I have a Triton IV with the model 249 Noise Blanker installed.
> The audio is raspy,
> whether listening to CW or Fone,
> on speaker or phones,
> NB switch In or Out.
>
> The manual sez it is an "IF type".
>
> Sounds OK w/o the NB installed.
>
> Schem shows input from the Rx side of the Tx/Rx mixer board,
> output to the Tx side of Tx/Rx mixer board, and output of SSB Gen. board.
>
> Anyone have a product sheet, schem, or setup info for the board?
>
> TNX NE4TT jamie