[TenTec] Band Stacking & USER1/2

[Dave Heil]

k6se at juno.com wrote:
> 
> After I stored my CW filter center frequencies in USER1 and USER2, I took
> advantage of the band stacking feature and stored 4 frquencies/modes/BW
> settings in each band stacking register for all 9 bands.
> 
> Today I did a USER1 recall and lost all of the band stacking I did (which
> takes a bit of time).  I did the band stacking thing for all 9 bands
> again and then did a USER1 store.
> 
> Happily, when I now do a USER1 recall, the band stacking register are
> intact.
> 
> If you use the USER feature, the moral of the story is:
> 
> After you make any changes in your setup, press and hold the USER button
> to store everything including your changes.

The four-per-band stacking registers are a nice touch but needed a bit
of work.  I suggested that bandwidth information be retained in the
registers and was happy to see this implemented in V 1.341.  I've now
lobbied to have the PBT and AGC settings retained in the registers in a
later update and have suggested that the 100k and 10k tuning steps be
done away with in favor of two additional settings between 10Hz and
100Hz.

Dave Heil K8MN