[TenTec] Re: Software defined surprises

K3BU at aol.com K3BU at aol.com
Sun Nov 9 21:34:21 EST 2003


In a message dated 11/9/03 9:12:09 PM Eastern Standard Time, ac5e at comcast.net 
writes:

>>But I don't really understand Yuri's insistance on keying with the PTT on 
the mike connector. Both the internal keyer and pin 3 (black jack) of the AUX 
connector key the TX. As will the key line if that is enabled on SSB. <<


Just the opposite, I don't want to key with PTT (it does on CW). I want PTT 
in CW mode through PTT line on mike connector (and SSB which is OK) and key CW 
through whatever separate KEY line.

The reason is my SO2R setup, where I need sometime to PTT the chain of 
TX-gizmos-AMP-ANT switches in CW mode without sending CW (just switch it to transmit 
mode).

The other reason is that TRlog can operate PTT and set the delays in 
software, so you can fine tune your system for minimum advance ptt and without 
introducing too much delay into CW timing, which sometimes at higher speeds starts 
interfering with ear - hand connection.

Many contesters prefer to use PTT on CW and SSB for complete control. BK in 
the contest situation is not that important. I do not need to listen for bk in 
short bursts of TEST K3BU, or when sending exchange, what's to BK there? WAE 
QTC or ragchewing or net operation is another story. 

Yuri, K3BU


More information about the TenTec mailing list