[TenTec] Omni 6 Rig Control

[George Tuncil]

Thanks, Dave.  I appreciate the feedback.  George W6AEA
  ----- Original Message ----- 
  From: Dave Edwards 
  To: tentec at contesting.com 
  Sent: Tuesday, November 25, 2003 10:21 AM
  Subject: Re: [TenTec] Omni 6 Rig Control


  I am not a Ten Tec wiz, but I would be shocked to hear that such functions
  as AF gain, power level etc. are computer controllable!!
  ...Dave
  ----- Original Message ----- 
  From: "George Tuncil" <w6aea at msn.com>
  To: <TenTec at contesting.com>
  Sent: Tuesday, November 25, 2003 1:10 PM
  Subject: [TenTec] Omni 6 Rig Control


  Thanks for all of the feedback regarding my rig control question.  I have
  connected my Omni to the COMM1 port via the 25 pin cable.  After doing the
  port selection criteria in my Writelog program, the only rig information
  that I have on my screen is frequency and mode.  Adjusting these parameters
  requires either manual action on the computer (new frequency/mode entry via
  a window) or adjustment at the rig on the tuning knob.  Any adjustments to
  any other parameter, such as power level, AF gain, etc. still must be done
  at the radio and are not visible on the screen.  It would sure be great to
  totally control the radio from the computer.  Any ideas of what I am doing
  wrong with either the Writelog program or my interface set-up?  Thanks in
  advance.  73.

  George W6AEA
  w6aea at msn.com
  _______________________________________________
  TenTec mailing list
  TenTec at contesting.com
  http://lists.contesting.com/mailman/listinfo/tentec

  _______________________________________________
  TenTec mailing list
  TenTec at contesting.com
  http://lists.contesting.com/mailman/listinfo/tentec