[TenTec] Need Hercules II Remote Contron Cable

[Gerald Bell]

Thanks, Pete

ac5e at comcast.net wrote:I had a couple and have made a couple more and they are not that much trouble to build. And no, I don't solder DB25's either. Not anymore, anyway. 


The current demand is small, so I use a ready made 25 wire DB25M/DB25F extension cable from my local radio parts store for the cable. They also stock the proper Molex connector shell and pins (in two bubble packs) for the cable. 


Cut and trim the cable close to the FM end, making sure the finished cable will be long enough. Generally, the cables use a variant of the standard RMA color code, black for 1, brown for 2, etc., and it's not hard to figure out. 

I write down the color code to pinout first, underlining the wires I will be connecting to the Molex. Then I make a layout of the Molex itself, writing in the colors to go to each pin. Being a belt and suspenders type, I crimp and solder the wires to the pins. When I have pins on the wires I need, it only takes a few more minutes, some care in making sure the pins are in the right holes, and I have a finished extension. 

73 Pete Allen AC5E




> Need Remote control cable (DB-25 connector on one end and 15 pin connector on 
> Hercules II remote control input). This cable is no longer in production at 
> Ten-Tec and originally connected the Paragon's DB-25 to the Hercules II remote 
> input. I need the cable to connect the model 311 Band-Data converter for the 
> Orion to the Hercules II.
> 
> Any help in locating a cable or a source for making such a cable would be 
> appreciated. My soldering skills are not up to DB-25 connectors!
> 
> Thanks,
> Michael Bell
> KB0DLR
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec