[TenTec] Jupiter + Studio One microphone settings

[Robert & Linda McGraw K4TAX]

Better yet, turn off the speech processor, set the rolloff to have minimum
effect or none, set the TX bandwidth to 2.4 KHz.  Adjust the mike gain so
that the ALC just begins to indicate ALC action.  Rule one, start with the
basic factory default settings before you change or add anything.

And yes the monitor output is simply an audio output from the TX audio
chain.  It does not represent the actual modulated RF signal.

73
Bob, K4TAX


----- Original Message -----
From: "Mark Erbaugh" <mark at microenh.com>
To: <tentec at contesting.com>
Sent: Friday, October 10, 2003 10:10 PM
Subject: Re: [TenTec] Jupiter + Studio One microphone settings


> Jason,
>
> The monitor output on the Jupiter and Pegasus doesn't reflect any TX audio
> adjustments. You need to listen to yourself in another receiver, or get
> on-air feedback from others.
>
> 73,
> Mark
>
> ----- Original Message -----
> From: "Jason Buchanan" <jsb at digistar.com>
> To: <tentec at contesting.com>
> Sent: Friday, October 10, 2003 10:57 PM
> Subject: [TenTec] Jupiter + Studio One microphone settings
>
>
> >
> > hi,
> >
> > I received my Studio One microphone today but am having a hard time
> > getting the settings right for the best audio quality.
> >
> > Does anyone have any recommendations how to configure the Jupiter to
> > handle this microphone, specifically the TX Width, speech proessor, tx
> > roll-off and mic gain?
> >
> > I seem to be missing the target by a mile.
> >
> > I used a pair of headphones to listen to the audio via the Monitor
> > option but I don't hear any sound differences as I adjust things.
> >
> >
> >
> > Thanks,
> > Jason W0JSB
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec at contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>