[TenTec] Jupiter + Studio One microphone settings

[Mark Erbaugh]

John,

If you look at the schematic for the Pegasus (so I assume the Jupiter as
well), the front and rear inputs go through identical input circuitry so
that there is no advantage to one over the other (other than whichever one
is more convenient for your particular setup). It's not like other radios
where the rear panel input bypasses the rigs audio processing and goes
straight to the balanced modulator.

I wasn't aware that the output audio going to the rear connector was any
different than the headphone output (other than level).

73,
Mark

----- Original Message ----- 
From: <N0KHQ at aol.com>
To: <tentec at contesting.com>
Sent: Saturday, October 11, 2003 9:25 AM
Subject: Re: [TenTec] Jupiter + Studio One microphone settings


> Set the rolloff at 100hz and the transmit band width to 3000. The will
give
> you a 2900 transmit bandwidth. If people tell you your too bassy raise the
> roll-off up to say...200hz.
>
> Dont expect the Studio One to perform miracles.....because it wont. To
find a
> mic that works with your voice through the Jupiter or any other radio is
> almost impossible. Mics are not individually custom built.
>
> You can feed your audio into two sources on the Jupiter......through the
> front mic or through the rear accessory socket.
>
> The best place to monitor your audio with head phones is through the rear
> accessory socket. use a good set of stereo headphones....something like
Sony
> MCR-V600. What you will hear is pretty close to what is being received by
other
> stations. Do not use the front phone jack.
>
> 73
> John / N0KHQ / St. Louis
>
> Always on 17M
> Antennas:
> You can build 'em better than you can buy 'em.
> Visit www. Hamuniverse.com - then click on Antennas
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>