[TenTec] MixW and Jupiter to send CW, but not as SSB

[John Clifford]

You need to use a serial-to-PTT interface, as found in most soundcard
interfaces or in the ARRL Handbook.  That way, the software can assert
DTR/RTS and trigger your PTT circuit.

I have used MixW with a BuxComm RASCAL interface and also with a RigBlaster
NOMIC interface, to send QSK CW with my rig in CW mode.  Works great.

 - jgc

John Clifford KD7KGX

Heathkit HW-9 WARC/HFT-9/HM-9
Elecraft K2 #1678 /KSB2/KIO2/KBT2/KAT2/KNB2/KAF2/KPA100
Ten-Tec Omni VI/Opt1
Alinco DR-605TQ
Icom T90A

email: kd7kgx at arrl.net


> -----Original Message-----
> From: tentec-bounces at contesting.com
> [mailto:tentec-bounces at contesting.com]On Behalf Of Jason Buchanan
> Sent: Sunday, October 12, 2003 1:10 PM
> To: tentec at contesting.com
> Subject: [TenTec] MixW and Jupiter to send CW, but not as SSB
>
>
>
> hi,
>
> Just wondering if it is possible to use MixW to send CW without using
> soundcard input?  I can move the frequency from MixW but I can't do
> anything else.
>
> I have set the baudrate to 57600 and checked the PTT via CAT box and the
> CW via CAT box also.  But no luck.  RTS set to always on, DTR is CW+PTT.
>
>
> Thanks,
> Jason W0JSB
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec