[TenTec] Titan 425 and Paragon 585 and lots of non-Ten-Tec gear

ED ww1n at tampabay.rr.com
Mon Sep 1 15:54:14 EDT 2003


I Would be interested in buying the Titan,Paragon,30L-1, KWM-2/supply/
312B-4.

If you could let me know what you would want for those peices including ups
shipping to Tampa, Florida I would be interested in buying them.
I would guess at the following UPS costs.
Titan...............$22.00
Supply............$44.00
30L-1..............$44.00
KWM-2/supply..$35.00
312B-4............$20.00.
Probably around $150.00 to $175.00 UPS.

Let me know.  ED
----- Original Message ----- 
From: "Stan Jacox" <KM6XZ at hotmail.com>
To: <tentec at contesting.com>
Sent: Monday, September 01, 2003 1:49 PM
Subject: [TenTec] Titan 425 and Paragon 585 and lots of non-Ten-Tec gear


> Hello list
> I recently posted a F.S. ad for selling my beloved amplifier and xceiver
and
> received an offer which I accepted. Unfortunately the potential buy could
> not raise the money  so they are both available again.
> I need to sell both because I am moving to Saint Petersburg Russia on the
> 15th of September for a while or permanently and neither unit is type
> accepted for importation plus the Titan far exceeds the limit for recip.
> licensing there of 100watts.
> I'm open for offers because I don't want either of these fine rigs to be
> sitting in storage deteriorating for a few years, they need to be used.
>
> Titan 425, late model with low hours on tubes, excellent condition with no
> blemishes.  $1600 .  My favorite amp of all.  It is hard to believe the RF
> section is so compact, attractive and high powered and yet weighs only
> 17lbs.  The PS. weighs about 50lbs
>
> Paragon I 585 with all filters installed  in excellent condition.  The
only
> mod is not really not a mod, the minor and major PLL boards have been
> completely resoldered after removing the old solder.  This solves a common
> problem of these units falling out of lock. This one has not dropped out
> once since reoldered the board 1 year ago.
>
> Other items I have that might be of interest: but not by Ten-Tec
>
> Motorola Service Monitor model 2002C  10khz-1ghz with the ovenized high
> stability master osc.  Good condition and perfectly aligned. $2,000.  I
> bought this unit new in the 80s for $19,000 ;>(
>
> Collins 312B-4 station control, in excellent condition, I took it new out
of
> the box 3 years ago, $125
>
> Collins 30L-1 fair condition, not collector condition but a solid and
stable
> performer $450, the best and easiest to use 115 volt mains self contained
> amp I've ever used.
>
> Stewart Warner R-390A with original meters and good condition. It is
missing
> the ballast tube which has been substituted by a 10 watt power resistor.
> The ballast tubes are available again for about $20-25.  The tube is used
as
> a quasi-filiiment regulator for the BFO and PTO tubes.  $400
>
> Halicrafters HT-32A, Good condition, works great, probably the best early
> filter type SSB rigs( I've had them all so speak with some authority),
> certainly the easiest to tune (except for the CE-200)  $150
>
> Signal/One CX-7A  Good condition except it has a open power transformer.
I
> bought a new Peter Dahl transformer for it but I never found the time to
> install it..  $400 with transformer.  Interesting rig, at the time of
> manufacture, the best built and most sophisticated ham rig available(and
> most expensive)
>
> Collins KWM-2 fair condition, not collector class but works well and
> original.  Including power supply Has optional Noise Blanker, $350
>
> Lots of H-P and Tektronix test equipment, RF and audio type.
> H-P606A H-P608E Marconi RF generators
> Lots of 465 scopes
> Many 403B, 400el, 400FL AC VMs etc.
>
> I also have a Kenwood TS-50S which I might sell but I was planning on
taking
> it to Russia because it is small and is type accepted.  If I sell it, I
want
> to replace it with a K-2 that I can use on batteries while backpacking.
> Beong a kit is does not need to be type accepted.  Overall, the TS-50S is
> very competent rig with a very sensitive receiver. Has optional CW filter
> installed.
>
> Thanks for your time reading my list
> 73
> Stan KM6XZ
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec



More information about the TenTec mailing list