[TenTec] Ten Tec Serial Numbers

[Mark Erbaugh]

Rod,

You could also do a test to check for the presence of the oven if you've got
the Omni VI hooked up for PSK. Tune a few hundred Hz from  WWV on 10 MHz.
watch the waterfall trace of the tone from the carrier.  You should see (and
hear) it drift as the rig warms up.  Turn the Omni VI off for a couple of
hours but leave the power supply on and repeat. That's probably more
reliable than relying on the SN as a previous owner may have or may have had
TT modify the radio.

73,
Mark

----- Original Message ----- 
From: "Rod Hotz" <42hotrodz at sbcglobal.net>
To: <tentec at contesting.com>
Sent: Wednesday, August 18, 2004 12:38 PM
Subject: Re: [TenTec] Ten Tec Serial Numbers


> Howdy Ken:
>
> Thanks so much...It's 42hotrodz at sbcglobal.net. The reason I want to
determine the age my VI is because of what I read in the TT manual regarding
the crystal oven in the VI. I only recently sold my Argo V and bought this
used VI, version 1. According to the manual, if you leave the power supply
turned on and the production date is 1994 or later, stability is improved
during the first couple of minutes after turning on the OMNI.
>
> Cheers...73,
>
> Rod
> K5BGB
>
> Ken & Linda Burrough <w8keb at 1st.net> wrote:
> Rod if you will send me your e-mail address I will send you the info so
you
> can find the age of your Omni VI.
>
> Ken-w8keb
> w8keb at 1st.net
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>