[TenTec] OUT OF HAM BAND MODIFICATION

[Rick and Karen Bunn]

Same place. Mine was a yellow wire loop labeled HAM and its about 1/3 from
the back of the radio on the right side. Not sure what the board is, but it
works well.

73 Rick
N4ASX

-----Original Message-----
From: tentec-bounces at contesting.com [mailto:tentec-bounces at contesting.com]
On Behalf Of Jim Bull
Sent: Wednesday, December 08, 2004 9:34 AM
To: tentec at contesting.com
Subject: Re: [TenTec] OUT OF HAM BAND MODIFICATION

Bob,
On my two Paragon's, the MARS/CAP/60M mod is accomplished by 
cutting/unsoldering the jumper wire on the logic board (Labeled "HAM")
and resetting the processor.  The jumper is located directly below the
9 volt memory battery.

NOW, if someone can tell me what/where the mod is on the Paragon II,
I would appreciate it VERY much.

Jim/Ke3nK
,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,

Robert Lutz wrote:
> Does anyone have the modification to make the Paragon transmit out of
> band
> 
> tnx  73   Bob
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 
> 


_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec