[TenTec] Argonaut V

ron roncasa at verizon.net
Sat Dec 11 12:10:18 EST 2004


Ah, another Rigblaster user put to dust :)

My Rigblaster was wired for the Scout 555 and had lots of fun working RTTY
and some SSTV. I attached a fan to the rear heat sink set RF to low power
and R'n'R' !!
With the 516, connections are breeze when you have the right software.
Again thanks all. (I'm keeping the Scout :)
Ron wb1hga
Because it's a Ten Tec!

Jack writes:

one does not need lots of stuff to run digital modes with MixW ...just an 
isolation transformer (obtained for a few bucks from Radio Shack with a 50K 
pot for gain control in series) in the lines from audio in and mike in from 
sound card to rig (non-ORION)

for CW one can build a simple switch as shown in the help files of MixW for 
keying one's rig

with the Orion cable from rig to sound card NO other connections need be 
made to work all but CW as noted above

jack ak7o

PS: i have a very little used RIGblaster with Icom mike cable i would be 
happy to sell for $50 shipping included

sold the IC756



 



More information about the TenTec mailing list