[TenTec] Re: Omni VI Roofing Filters

[Tommy]

Ken,

I haven't looked recently, but from what I understand from George 
and another source, the Inrad roofing filter for the Plus is going 
to be selectable, using the N1 and/or the N2 button on the front 
panel. The filter is housed in the Inrad standard filter enclosure, 
and the last info I had was that it will physically be mounted on 
the 9MHz filter board, with three coax cables to be attached within 
the Plus. Think you will also need to supply +12vdc to it, but 
knowing George, the installation should be rather painless!

Tom - W4BQF

"So you have enemies?
Good.
That means you have stood up for something,
sometime in your life."
--Sir Winston Churchill--

----- Original Message ----- 
From: "Ken Brown" <ken.d.brown at verizon.net>
To: <tentec at contesting.com>
Sent: Friday, December 24, 2004 1:56 PM
Subject: [TenTec] Re: Omni VI Roofing Filters


> Where will this new Inrad roofing filter for the Omni VI go? In 
> place of Y1 or in place of Y2? Changing Y2 will affect SSB TX, 
> unless there is some kind of additional switching circuitry added. 
> Or will it just plug in to an  "optional filter" position?
>
> DE N6KB
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec