[TenTec] Frequency accuracy...
Bill Tippett
btippett at alum.mit.edu
Wed Dec 29 11:05:36 EST 2004
AA6E wrote:
>A different method. Listen on 10 MHz in CW mode and
press "spot". You can easily hear the beat between
your spot tone and the WWV carrier to +/- 1 Hz. Right
now, I get 9.999973 MHz, meaning that my TCXO must be
2.7 ppm high.
Same method I use. From a COLD start (shack temp
~60 degrees F), my unit went from 9.999967 to 9.999975
in about 30 minutes, then back to 9.99967 after 2.5 hours.
That's a total deviation of 8 Hz, which is well within
TT's +/- 3 ppm stability spec which is +/- 30 Hz at 10 MHz.
My unit is 16 months old and has never been touched since
it left the factory. Unlikely I will recalibrate since
the absolute 33 Hz offset is not worth the bother to me.
Also, note that TT does not specify frequency accuracy,
only frequency stability.
73, Bill W4ZV
More information about the TenTec
mailing list