[TenTec] Corsair II power connections - got answer - thanks!

[Tim Logan]

Thanks folks - got what I needed from Denton and Duane :-)

denton wrote:

> pins 2 & 3 go to the power push pull knob in the front of the corsair 
> and are only for turning a ten tec power supply on and off
> pin 1 is the B=
> pin 4 is ground, both chassis and power supply.
> with the ampex breaker and astron power supply, you should disregard 
> pins 2 & 3 and use the circut breaker to turn the cosair on and 
> off..or just leave it on all the time.
> ----- Original Message ----- From: "Tim Logan" <nz7c at cox.net>
> To: <tentec at contesting.com>
> Sent: Wednesday, December 29, 2004 6:14 PM
> Subject: [TenTec] Corsair II power connections
>
>
>> Hi  -
>> I'm a little confused about the Corsair II power plug pin 
>> connections. I am using an Astron 25 amp PS and I have an Ampex 
>> breaker in my power cord. The cord is wired to pin 1 and 4 of the 
>> power connection. These connections do not allow me to turn the rig 
>> off and on from the front. Page 1-2 of the manual I THINK indicates 
>> that you should use pins 2 and 3 instead of 1 and 4 if you want to 
>> power the rig on and off from the front. Is that correct or am I 
>> misreading the manual. Thanks for any help with my dopey question!
>> 73/Tim NZ7C
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>